Z34 370z wheel nut adapter (set of 20) Front Suspension

Z34 370z wheel nut adapter (set of 20) Front SuspensionWhen installing wheel spacers in conjunction with the OEM wheels you often run into issues with the factory flange style wheel nuts. Wheel spacers (including ours) often have longer studs which bottom out inside the OEM nuts. To get around this we have made these adapters which allow the use of a 60 tapered wheel nut in conjunction with the OEM wheels. Now you can use any off the shelf 60 tapered wheel nut. Machined from 6061 T6 aluminium Sold as a

These inner tie rods are an OEM replacement only

NOTE – Due to nature of seating the rack in a different position to OEM and both the subframe and bushes being solid

97mm GTR/Z32 300ZX HIGH MISALIGNMENT TIE ROD ENDS GTRX-TROD 77mm GT86 / GR86 / ZC6 BRZ HIGH MISALIGNMENT TIE ROD ENDS GT86-TROD 97mm R32/R33 SKYLINE STEERING ANGLE KIT R33X-SSTR 70mm IS200/IS300 STEERING ANGLE KIT XE10-SSTR 110mm

The end result is similar to an aftermarket gearbox mount but without the extra noise and without the extra cost

- Heat sleeve included (and must be used)

NOTE: You may need hub centric rings that we have available to suit your aftermarket wheels etc

2800 in 32

- 6mm steel plate

NOTE: Will fit both LHD and RHD vehicles

The OEM front lower arm pivots a significant amount throughout suspension travel which causes premature wear

In addition to the minimal spacing

2748 mm BALL BORE SIZE BALL BORE SIZE 0