T2 stainless steel turbo to manifold gasket Weld In Plates

T2 stainless steel turbo to manifold gasket Weld In PlatesThis stainless steel turbo to manifold gasket is a direct replacement of the standard unit and is an upgrade from your general carbon composite manifold gaskets which are prone to blowing out. Race tested and a proven performer Replacement for Nissan part 14415 17MOO

- 4 Piece Set

The GKTECH solid gearbox mount is a direct replacement of the standard item and drastically increases the feel of the gearbox

Our arms feature high quality 5/8" Teflon lined pillow ball rod ends which eliminate the flex found in factory rubber bushing offering a more direct and predictable feel

Static Radial Load (kg) 53

If you're running R32 GTR calipers on your R32 GTR then have a think about upgrading your rotors from 296mm to a whopping 324mm's

You may need to trim the shaft down around 3-4mm's if it is touching

- Replacement for Nissan part 14415-17MOO

It also leads to uneven tire wear and reduced steering precision

Sold as a pair these wheel adapters bolt on to your standard hub just like a normal wheel spacer however 1 of your standard studs is then replaced with a longer stud which runs through the adapter and acts as the 5th stud

com/blogs/news/s-chassis-rear-subframe-comparison

4500 mm ROD END MISALIGNMENT ANGLE ROD END MISALIGNMENT ANGLE 24 degrees 24 degrees ROD END STATIC LOAD CAPACITY (lbs) ROD END STATIC LOAD CAPACITY (kg) 30

S145-3065) V1 and V2 Rear LCA's (SKU=REAR-LCAX)