Flywheel/Pulley Holder - Tusk grips

Flywheel/Pulley Holder - Tusk gripsFlywheel Pulley Holder Tusk Details The Tusk Flywheel Pulley Holder is designed to hold a 60mm 120mm flywheel to make the removal and installation of your flywheel simple and easy. Two adjustment holes in the belt make it easy to adjust to different sizes. Easily adjustable to fit a 60mm 120mm (2 3 8" 4 3 4") flywheels. Tough plastic belt holder won't mark surfaces. Suitable for flywheel and clutch pulleys on a large range of motorcycles and ATVs

Kit contains all necessary O-rings and diaphragms to rebuild one fuel petcock

Lighter than stock

IMPORTANT NOTE: Any bore kit for the Z125 must be used with an aftermarket fuel controller to prevent a lean condition and damage to your engine

Eye to Eye Length = 353mm

so it can not be used

VM26 by Mikuni is built with quality materials for consistent

May work for heavier riders depending on skill

We use only USPS Priority and Express Service when shipping parcels to anywhere other than the USA

The perfectly balanced combination of those three factors allow a more precise tuning and much smoother damping action than anything else currently available for minimoto

Mikuni VM26mm Performance Carb Kit for KLX/DRZ 110 Stock and Mod Motors w/Stock Head

if desired you can drain and refill with 5oz of your choice of quality fork oil

oil seal - see picture)