Fire hazard testing - Glowing/hot-wire based test methods. Glow-wire flammability test method for end-products (GWEPT) has-tracked-changes — supports for wind turbines

— supports for wind turbines

Testing laboratories of chemical disinfectants and antiseptics

contributing to urban cooling through evapotranspiration and providing micro-climatic effects that can reduce energy demands in buildings

This standard is not applicable to slings that are manufactured before the date of publication of this standard

Fire hazard testing - Glowing/hot-wire based test methods. Glow-wire flammability test method for end-products (GWEPT) has-tracked-changes — supports for wind turbines1 Scope This part of IEC 60695 specifies a test method on an end product. It is intended to simulate the effects of thermal stresses produced by an electrically heated source to represent a fire hazard. This test method is used to check that, under defined test conditions, an end product exposed to an electrically heated source has either a limited ability to ignite or, if it ignites, a limited ability to propagate flame. However, the fire hazard