Rubber or plastics-coated fabrics. Determination of resistance to combined shear flexing and rubbing Ingestion-build-67170 The response of the receiver

The response of the receiver to impulsive noise will vary with the spectrum amplitude of the noise and the noise pulse-repetition rate

NOTE Additional targets for assessing the output quality of black-and-white scanners using continuous tone and colour are referred to in ISO 12653-2

BS EN ISO 3506-3 specifies the mechanical properties of set screws and similar fasteners not under tensile stress made of austenitic stainless steel

Establish an asset management system to optimally and sustainably manage physical assets

Rubber or plastics-coated fabrics. Determination of resistance to combined shear flexing and rubbing Ingestion-build-67170 The response of the receiver1 Scope This International Standard specifies two methods of evaluating the resistance to combined shear flexing and rubbing of rubber or plastics coated fabrics. Rubbing is either forced by application of a pressure foot (method A), or is caused by simple contact between the faces of the test pieces (method B). Method B (without application of the pressure foot) is preferred in all cases where the foot would damage the test piece through an abrasive